summary.
Edit me
DJI S1000 A2
overview
| Type |
Details |
Type |
Details |
| frame |
|
FC |
|
| motor |
|
ESC |
|
| RC |
|
mode |
|
| weight |
|
class |
|
| battery |
|
air-time |
|
| configurator |
|
last updated |
|
checklist and indicator status
- Servo power will shut off 3 seconds after the landing gear has reached its target position.
- When powering on the system, if the transmitter switch is in the [Upper] position, the LED will flash red quickly as a warning. Toggle the switch to the [Lower] position to continue.
- If there is an abnormal signal or no signal input into the “IN” port, the LED will slowly flash red. Check receiver and connections for problems.
- If servo power consumption is too high, the LED will light up red. If this lasts more than 4 seconds, the landing gear will lower and the LED will flash green slowly. Re-calibration is needed beforeflying.
- A2 flight control system users can use the A2 Assistant to set intelligent gear on the “Advanced” page. Refer to the “A2 user manual” for details
| LED control |
Board Indicator |
|
| System normal |
— Solid green. |
|
| Calibration required |
Blinks rapid green. |
|
| Recalibration required |
Blinks slow green. |
|
| Calibration failed |
— Solid yellow. |
|
| Enter calibration mode |
Blinks rapid yellow. |
|
| System calibrating |
Blinks slow yellow. |
|
| Motor stalled |
— Solid red. |
|
| Unsafe startup alert |
Blinks rapid red. |
|
| Input signal abnormal |
Blinks slow green |
|
compass calibration
Using the remote controller:
- Quickly flip the control mode switch from P mode to A mode, and then back to P mode three times, and the Aircraft Status indicator will display a solid yellow light.
- Hold and rotate the aircraft horizontally 360 degrees, and the Aircraft Status Indicator will display a solid green light.
- Hold the aircraft vertically with nose pointing downward, and rotate it 360 degrees around the center axis, Recalibrate the compass if the Aircraft Status indicator is solid red.
Tags:
