summary.
Edit me
dji quad custom frame
overview
| Type | Details | Type | Details |
|---|---|---|---|
| frame | FC | ||
| motor | ESC | ||
| RC | mode | ||
| weight | class | ||
| battery | air-time | ||
| configurator | last updated |
checklist and indicator status
- Servo power will shut off 3 seconds after the landing gear has reached its target position.
- When powering on the system, if the transmitter switch is in the [Upper] position, the LED will flash red quickly as a warning. Toggle the switch to the [Lower] position to continue.
- If there is an abnormal signal or no signal input into the “IN” port, the LED will slowly flash red. Check receiver and connections for problems.
- If servo power consumption is too high, the LED will light up red. If this lasts more than 4 seconds, the landing gear will lower and the LED will flash green slowly. Re-calibration is needed beforeflying.
- A2 flight control system users can use the A2 Assistant to set intelligent gear on the “Advanced” page. Refer to the “A2 user manual” for details
| LED control | Board Indicator | |
|---|---|---|
| System normal | — Solid green. | |
| Calibration required | Blinks rapid green. | |
| Recalibration required | Blinks slow green. | |
| Calibration failed | — Solid yellow. | |
| Enter calibration mode | Blinks rapid yellow. | |
| System calibrating | Blinks slow yellow. | |
| Motor stalled | — Solid red. | |
| Unsafe startup alert | Blinks rapid red. | |
| Input signal abnormal | Blinks slow green |
compass calibration
Using the remote controller:
- Quickly flip the control mode switch from P mode to A mode, and then back to P mode three times, and the Aircraft Status indicator will display a solid yellow light.
- Hold and rotate the aircraft horizontally 360 degrees, and the Aircraft Status Indicator will display a solid green light.
- Hold the aircraft vertically with nose pointing downward, and rotate it 360 degrees around the center axis, Recalibrate the compass if the Aircraft Status indicator is solid red.