Servo power will shut off 3 seconds after the landing gear has reached its target position.
When powering on the system, if the transmitter switch is in the [Upper] position, the LED will flash red quickly as a warning. Toggle the switch to the [Lower] position to continue.
If there is an abnormal signal or no signal input into the “IN” port, the LED will slowly flash red. Check receiver and connections for problems.
If servo power consumption is too high, the LED will light up red. If this lasts more than 4 seconds, the landing gear will lower and the LED will flash green slowly. Re-calibration is needed beforeflying.
A2 flight control system users can use the A2 Assistant to set intelligent gear on the “Advanced” page. Refer to the “A2 user manual” for details
LED control
Board Indicator
System normal
— Solid green.
Calibration required
Blinks rapid green.
Recalibration required
Blinks slow green.
Calibration failed
— Solid yellow.
Enter calibration mode
Blinks rapid yellow.
System calibrating
Blinks slow yellow.
Motor stalled
— Solid red.
Unsafe startup alert
Blinks rapid red.
Input signal abnormal
Blinks slow green
compass calibration
Using the remote controller:
Quickly flip the control mode switch from P mode to A mode, and then back to P mode three times, and the Aircraft Status indicator will display a solid yellow light.
Hold and rotate the aircraft horizontally 360 degrees, and the Aircraft Status Indicator will display a solid green light.
Hold the aircraft vertically with nose pointing downward, and rotate it 360 degrees around the center axis, Recalibrate the compass if the Aircraft Status indicator is solid red.
| 
|
Preview